NEAR 7XL Installation & User Manual - page 13
9
Software Control
From the Home/Level window the following
Configuration Settings
are available:
1.
Input Source: Either of the following three options can be selected as the active input for the
InA and InB input channel sources:
Balanced Input: Input is coming from rear panel balanced XLR connectors.
Unbalanced Input: Input is coming from rear panel unbalanced RCA connectors.
Noise Generator: Input coming from the internal Noise Generator. Further options are
accessible in the “Noise Generator” section.
2.
Noise Generator: Allows selection of White or Pink noise. The Level slider is used to adjust
the Noise Level at the inputs, with a range from -40dBV to 0dBV.
3.
Front Panel LEDs Mode: Select what the front panel A and B LEDs display:
Inputs only: Displays signal and clip for InA and InB only.
Outputs only: Displays signal and clip for Amp A and Amp B only.
Input and Output: Displays the signal and clip for both In/Amp A and In/Amp B.
Note: Line Output LED always displays signal and clip of Line Output only.
4.
Sleep Mode: Enable/Disable sleep mode feature. When enabled, allows amplifier to enter
low-power mute mode after a 3 minute period of no audio. Normal power and un-muting is
instantaneous after audio detection.
5.
VU Meters: VU Meters are indicate the Input/Output Levels from -15dBV up to +9dBV at
different tap points along the signal stage. Specifically for the Inputs, BG (Before Gain), AG
(After Gain), and AC (After Compressor), and for the Outputs, AG (After Gain), BL (Before
Limiter), AL (After Limiter).
6.
Input/Output Level Sliders: Allows adjustment to the Input/Output Levels, ranging from
-60dBV up to +12dBV.
7.
Mute Button: Allows Muting of the related Input/Output channels.
8.
Speaker Drive Selectors: on the Amplifier Output channels it is possible, independently, to
define the load type the channel has to drive.
16 Ohm/100V – with this selection, the amplifier can drive 16 Ohm Loads or Direct Drive
100V Constant Voltage line.
4-8 Ohm/70V - with this selection, the amplifier can drive 4-8 Ohm Loads or Direct Drive
70V Constant Voltage line.
9.
Block Diagram: Shows the sequence of the Input and Output processes. Clicking with the
mouse pointer on the desired Input/Output process block, will link directly to the page
containing the selected process. Furthermore, clicking on the “loudspeakers icons” on the
block diagram, it is possible to Mute the related Input/Output.
1
2
3
4
5
6
7
8
9