Nebula 200W Beam Moving Head User Manual - 2.3. Information Interface
2.3. Information Interface
Option
Instruction
Software version
Current software version
Total usage time
Total usage time is accurate to minutes
Usage time of this
time
Usage time of this time is accurate to minutes
DMX channel value
Enter into the son interface from this, shows the numerical
and percentage channel value for check
System error record If the red ERR light shine, it means the light has operation
error, the details can be view in son interface. After the
check, can click "OK" button, the error record will empty
Note: Sometimes it's not really the installation problem of
hall or optocoupler, but the motor line are reversed.
2.4. Manual Control Interface
The interface is used to control the current light, not only does not belongs to the slave
state (don’t receive DMX signal), but also does not belong to the master state (don’t
send DMX signal).
Option
Instruction
Reset
Press the “OK” button, see the confirmation dialog box,
click" OK "button again, enter reset interface, all motor
reset
Color wheel
0~255
Press the "OK" button to enter edit state. And it chosen
the hundred position, press the "Up" and "Down" button to
change address code. Press "OK" button once again to
select ten position editing. Click "OK" button twice again
……
0~255
Gobo speed 0~255
XY coder
On
Use the coder(optocoupler) to judge whether out of step,
and correct position automatically
Off
Don’t use the coder( optocoupler ) to correct position
NO
DMX
signal
Retai
n
According to the original state to continue running
Reset Motors return, stop running
Screen
protection
On
No operation for 30 seconds, the backlight will be off
Off
The backlight will be on all the time
Lamp on
Off
After power on reset directly, bulb doesn’t light up(need to
use the menu or controller to manual light bulb)
On
After power on, bubble light automatically, and to wait on
the bulb light successfully, then reset.
Default
Settings
Click "OK" button, see the confirmation dialog box, click
"OK" button again to recover default Settings