Nebula 200W Beam Moving Head User Manual - 2.5. Advanced Interface
to select the unit editing. Click again exit editing state.
Lamp
control
On
Off
2.5. Advanced Interface
The password is "up and down up and down". Operation process is: press the "Up" key
(appear first "*"), click again "Down" key (appear the second "*"), then press the "Up" key
(appear third "*"), click again "Down" key (appear fourth "*"), and press the "ok" button to
verify password.
Option
Instruction
Touch
screen calibration
Into the calibration interface, according to cross cursor
indication to touch the corresponding position, if four position
to receive the correct data, then complete calibration and
keep calibration data.
If calibration fail, this process will continue cycle down, can
by press the "OK" button at any time to stop calibration
Reset calibration
Enter the son interface, can adjust the X, Y motor reset
position, to make up for the hardware installation error.
Be different from the address code and channel value, reset
calibration does not support unit, ten, hundred separate
editing, also does not support long press, and must be
calibrated step by step as 1 for unit.
Note: please do not do reset calibration when the motor is
running! If the motors are running, please reset calibrate after
the motors stop
When necessary, please perform a reset operation before
reset calibration.
CHANNEL
CHANNEL MODE
16
20
1
COLOUR WHEEL
COLOUR WHEEL
2
STOP/STROBE
STOP/STROBE
3
DIMMER
DIMMER
4
STATIC GOBO CHANGE STATIC GOBO CHANGE
5
PRISM INSERTION
PRISM INSERTION
6
PRISM ROTATION
PRISM ROTATION
7
EFFECTS MOVEMENT
(UNUSED)
EFFECTS MOVEMENT (UNUSED)
8
FROST
FROST
9
FOCUS
FOCUS
10
PAN
PAN
11
PAN FINE
PAN FINE
12
TILT
TILT