NEC 120Ef User Manual - page 26
of
37
Making Connections 3-2
1. Make sure that the Disk Array Controller (S-ATA) is installed in the system. If not,
install the Disk Array Controller into the system.
Note:
Refer to the Disk Array Controller user’s guide for details
on installing the Disk Array Controller.
2. Connect the LED cable connector (black) to the LED connector pins (2) of the HDD
Cage.
Figure 3-1: Connecting the LED Cable
Note:
- The LED Cable is an accessory of the system.
- Refer to the system user’s guide for details about connecting the LED
cable to the motherboard.
BLACK cable
RED cable
LED cable