NEC E322 User Manual - Rs-232C Port Specifications
English-17
English-16
8
USB/SERVICE – Insert USB storage device to view photos and listen to
the music /This USB slot is for future software upgrades
9
RS-232C – Input from external equipment such as a PC or AV control
system in order to control RS-232C functions
Once your AV device is connected, press the Source button on the remote
control to select the relevant source to view (ex: Press COMP button to select
“Component” if you have connected a source to the Component input )
RS-232C Port Specifications
PC control of the TV
Attach an RS-232C cable cross-type (commercially available) to the supplied
Din/D-Sub RS-232C for the connections
Note: This operation system should be used by a person who is accustomed
to using computers
Communication conditions
Set the RS-232C communication settings on the PC to match the TV's
communication conditions
The TV's communication settings are as follows:
Baud rate:
9,600 bps
Data length:
8 bits
Parity bit:
None
Stop bit:
1 bit
Flow control:
None
Communication procedure
Send the control commands from the PC via the RS- 232C connector
The TV operates according to the received command and sends a response
message to the PC
Do not send multiple commands at the same time Wait until the PC receives
the response before sending the next command
Power Mode Status
Mode
LED
Status
VGA
AV
Component
HDMI 1-3
TV
On
Blue
v
v
v
v
v
Power
Saving
Purple
v
-
-
-
-
Standby
Red
v
v
v
v
v
Power saving support automatically power on when signal appear
Standby to power on by touch up remote or keypad power button