NEC E324 User Manual - Connect to The Power Source

English-15

English-14

English

Connect To The Power Source

The display should be installed close to an easily accessible power outlet  

Fully insert the prongs into the power outlet socket  A loose connection may 

cause image degradation

If there is power to the display, the front LED at the bottom of the display will 

be either none or red  A red LED means the display is in standby mode

Power On/Off Your New LCD Display

Press the power button on the remote control or press the power button 

located on the side of the display  The display will power on

Power button

or

Power Mode Status

Mode

On

Standby

Warming up

LED Status

None

Red

Blinking Red

Warming up mode can automatically turn the display power on when signal 

appears

Press the power button on remote control or on side keypad can power on the 

display in standby mode