NEC MC33M/B-K User Manual - page 17
17
System Configuration
1
Turn on the power and immediately press
The BIOS setup utility will then be displayed.
• You can use the keyboard.
• Select the menu bar cursor using
>
>and settings using
>
>. Open
the pop menu using or >
> to change the setting values. • You can move the cursor in the settings (e.g., Hour/Minute/Second of the system time) using • For the settings with , press to return. Please follow these steps to restore your system to the default factory settings. 1 Enter the BIOS setup utility. 2 Select [Exit] on the Menu bar, using > or > keyboard key. The menu appears. 3 Select [OS Optimized Defaults] using the > keyboard key, and press 4 Follow the steps belows. Select [Enabled] and press [Attention!] is displayed. If it has already been [Enabled], [Attention!] is not displayed. Proceed to step 6. Select [Disabled] and press [Attention!] is displayed. If it has already been [Disabled], [Attention!] is not displayed. Proceed to step 6. 5 Confirm that [Yes] is selected and then press The computer is configured to run on the Windows 8.1 or Windows 7 system. 6 Press the The message [Load Optimized Defaults?] appears. 7 Confirm that [Yes] is selected and then press This will load the default factory setting values. 8 Press the Message [Save configuration and exit] appears. 9 Confirm that [Yes] is selected and then press These setting values are saved, the BIOS setup utility will finish, and your computer will restart. Configuration is now complete. The BIOS setup utility • Do not turn your computer off with the power switch while in the BIOS setup utility. If you wish to turn the computer power supply off after you have completed the BIOS setup, be sure to exit the BIOS setup utility. When the Windows system has started up, shut down the computer from the Windows screen. • To change the [Devices] menu settings, select [Power] and [Restart] from the charm bar. When the computer is restarted, call the BIOS setup utility. Entering the BIOS setup utility • If the BIOS setup utility is not displayed, press the • When the BIOS setup utility is started and if [Load Previous Values?] is displayed, press BIOS setup utility basic operation 10 Restoring default factory setting values