NEC N-730E User Manual - Getting Started
U
7
Unpacking
N.B. When you unpack the oven, check that the
product is free from damage. Damage or any missing
parts must be reported immediately to the retailer.
The oven, parts of the oven or the accessories may
be wrapped by a protection foil. If so, you must
remove this foil before using the oven. Do not leave
packing material so that small children can play with
it. This can be hazardous.
Installation
1. Remove any promotion label from the door.
2. Install the oven on a flat, level surface. The
surface must be strong enough to safely bear the
weight (13.5 kg) of the oven, and the contents. To
avoid the possibility of causing vibration or noise
the oven must be in a stable position.
3. Keep the oven away from heat and water.
Exposure to heat and water can lower oven
efficiency and lead to malfunctioning, so be sure
to install the oven away from heat and water
sources.
4. Do not block air vents on the top and the sides of
the cabinet and also do not place any articles on
the top of the oven. If air vents are blocked during
operation, the oven may overheat, and this may
lead to malfunctioning. Hot air escapes from the
vents, so be sure not to obstruct it or let curtains
come between the oven and the rear wall.
5. Place the oven as far away from radios and TV’s
as possible. Some interference may occur if it is
placed too close to a radio or TV, so keep them
as far apart as possible.
6. If positioned in a corner, leave a gap of at least
5.0
cm from the walls to meet ventilation
demands.
Important! The oven can be placed almost anywhere
in the kitchen. Make sure the oven is placed on a flat,
level surface and that vents as well as the surface
underneath the oven are not blocked (for sufficient
ventilation).
Connecting to the mains
The oven is delivered with the power cord and a plug
for 220 - 2
4
0V, 50Hz, earthed socket outlet. Earth
protection minimises the risks should a short-circuit
occur. Check to ensure the voltage of the oven
matches the supply.
N.B. If the oven is connected to the socket via an
extension cord, make sure the cord is earthed.
WARNING! This appliance must not be used on a
non-earth protected power supply.
Contact an electrician if you are uncertain regarding
electrical connection of the oven or provision of earth
protection of the supply.
If this appliance is
fitted with a non-rewireable plug
for which your socket
is unsuitable, the plug should
be cut off and the
appropriate plug fitted. If it is
necessary to change the
fuse in a non-rewireable
plug, the fuse cover must be
refitted. If the fuse cover
is lost or damaged, the plug
must not be used until a
replacement is obtained.