NEC V850 ZigBee Pro User Manual - page 15
Manual is about: 32-bit V850 ZigBee PRO Gateway Development Platform
of
59
Figure 2-7 WriteEZ3 Device Setup
Write the same sample programs to the other TK-78K0/KF2+UZ boards.
Then, set the position of the switches as shown below:
Table 2-3 Operation mode setting for the TK-78K0/KF2+UZ
SW1 – 1, 2, 3, 4, 5, 6 and 7
OFF
SW1 - 8
ON
SW5
UART
When you run the application, you can run it as a stand-alone system by setting
JP1 to 2-3 pin short and using a 6LR61 9V battery connected to CN2. For further
details about the power supply settings, please refer to section
Apply the relevant power supply source to the target boards.
If you select [Display] -> [Network Configuration] and if a Device is connected
wirelessly, you can see the red line.
Sample Program
Chapter 2
User's Manual U19026EE3V0UM00
15