NEC V850 ZigBee Pro User Manual - page 33
Manual is about: 32-bit V850 ZigBee PRO Gateway Development Platform
of
59
Select the COM port number you connected your PC with the TK board. All of
COM port numbers available on your PC will be displayed.
Set ”Speed” to 38400, ”Frequency” to 5.00, “Multiply rate” to 4.00.
Then, press “OK”.
Figure 5-4 Setting the parameters for the flash programming session
Next, load the HEX file that you want to program to WriteEZ1. Click “Load” to
open the file “mac_app.hex”, which you created in the section
Hex file for flash programming"
When successfully loaded, “Success read HEX file.” is displayed.
Programming the TK-850/SG2+UZ with WriteEZ1
Chapter 5
User's Manual U19026EE3V0UM00
33