North Star NSR 17CS Installation And Operation Manual - page 14
14
12 OR 24 HOUR CLOCK
All time displays are shown in 12 hour (AM/PM) clock
format at the default setting. If 24 hour clock format
is desired, follow steps below:
1
. Press the SET button and hold for three seconds,
until the “Recharge Time” screen is displayed.
2
. Again, press the SET button and hold for three
seconds, until the model code screen is displayed.
Customizing Features / Options
3
. Once in this display, press the SET button again
and one of the two displays in Figure 33 is shown.
4
. Press the UP (
È
) or DOWN (
–
) buttons to select
the time format.
5
. Press the SET button twice to return to the normal
time of day screen.
GALLON OR LITER VOLUME UNITS
At the default setting, all water flow rate and usage
displays are shown in gallons (GALS). Alternatively,
you may select liters for volume units to display.
1
. Press the SET button and hold for three seconds,
until the “Recharge Time” screen is displayed.
2
. Again, press the SET button and hold for three
seconds, until the model code screen is displayed.
3
. Once in this display, press the SET button twice
and one of the two displays in Figure 34 is shown.
FIG. 34
FIG. 32
FIG. 33
4
. Press the UP (
È
) or DOWN (
–
) buttons to select
the volume units.
5
. Press the SET button once again to return to the
normal time of day screen.
Questions? Call Toll Free 1-800-972-0135
or visit
www.northstarwater.com
When you call, please be prepared to provide the model and serial number,
found on the rating decal, located on the rim below the salt lid hinges.