Northern Tool Electric fireplace heater Operation Manual - page 2
2
NOTE:
Procedures and techniques that are considered important enough to emphasize.
CAUTION:
Procedures and techniques, which, if not carefully followed, will result in damage to the equipment or
personal property or may cause personal injury.
WARNING:
Procedures and techniques, which, if not carefully followed, will expose the user to the risk of serious injury,
illness or death.
WARNING:
This is a 1500-watt heater and parts become hot when in use. Be sure to maintain a personal distance and keep any
combustible material at least three feet away from the heater. The area directly around and under the heater must be
clear and free of any obstructions.
KEEP CHILDREN AND PETS AWAY FROM HEATER AND CONTROLS.
Operating Instructions
Once the fireplace heater insert has been properly installed and connected to a ground electrical outlet, it is ready to
operate. Note: ensure the circuit breakers for the power supply are turned on.
The controls are located behind the grill below front glass and can be accessed by pulling the grill up from the top,
forward and down.
Lift front grill to access the switches.
1. The round dial on the far left is the thermostat that automatically turns the heaters on and off to maintain a
constant temperature. Turn the thermostat dial to the right to increase the desired temperature and the left to
lower it. Once the room reaches the desired temperature, turn the thermostat dial counter-clockwise until you
hear a click. Leave in this position to maintain the room temperature at its current setting.
2. The switch on the left turns the heater on at 1500 watts.
3. The middle switch turns the heater on at 750 watts.
4. The right switch is the main power switch “ON/OFF”.
5. The round dial on the right adjusts the intensity of the simulated flame effect. Turn this dial until desired flame
effect is reached.
Maintenance
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire or electric
shock.
Cleaning
Before cleaning any parts of the fireplace make sure to first turn off the controls and then unplug the unit from power
source.
1500W
750W
ON/OFF