Northern Tool Electric fireplace heater Operation Manual - page 3
3
CAUTION: Wait until the unit has completely cooled before attempting any cleaning.
Cleaning glass door: Remove dust with clean dry cloth. Remove fingerprints and other marks from glass door by
using a clean damp cloth. Do not use abrasive cleaners or spray liquids on glass door surfaces.
Metal and metal painted parts should be cleaned with clean damp cloth only. Do not use abrasive cleaners or spray
liquids on this surface.
Replacing the Log/Flame Effect Light Bulbs
There are two 40-watt light bulbs located under the log-set bed. Remove the 4 screws on the cover located on the back of
fireplace and then remove the rear cover of the unit.
CAUTION: The bulbs in your unit can become extremely hot. Allow at least 15 minutes between turning off the unit
and removing the light bulbs to avoid hot bulbs coming in contact with the skin.
To remove bulbs: Hold socket and pull the old bulbs out.
To replace bulbs: Hold socket and push in the new bulbs
Help Hints: For convenience, if one light bulb burns out, it may be a good idea to replace both of the light bulbs at the
same time.