NorthRoad Technologies Geyser 6000–3.0 Installation & Owner's Manual - page 2
––
SAFETY INFORMATION
Examine your water tank; make sure it is not rusty or leaking. Depending on the condition and age of the
tank, this may be the best time for replacement. Before installing the GEYSER 6000–3.0™, make sure that the
water heater is on a flat surface and properly secured.
SAFETY INFORMATION (PLEASE READ AND FOLLOW THIS
SECTION CAREFULLY TO PREVENT ACCIDENTS OR INJURIES).
The GEYSER 6000–3.0™ Heat Pump Water Heater must be installed in accordance with local and national
codes and the instructions in this manual. Before beginning the installation, read the entire manual and
check the local, state, and national building, electrical, and plumbing codes or authorities. Failure to
install according to these instructions and codes may result in property damage, bodily injury, or death.
•An air discharge fan is located on the unit. Extreme caution must be exercised to ensure that any foreign
objects do not enter the fan area.
•Do not stand or sit on unit. Do not allow children to play on or near the unit.
•Disconnect all power before removing cover (note that there is no need to remove the cover except to
adjust the temperature settings).
Internal components may be hot to the touch. Please allow unit to cool completely before touching any
component.
•Disconnect power before installing or servicing the GEYSER 6000–3.0™.
•Ensure that the power receptacle is rated for 5 V. and at least 5 Amp.
•Ensure that the electrical supply has proper overload fuse or breaker protection rated for at least 5
amps. It is suggested to use a dedicated outlet.
•Wear eye protection during the installation.
The GEYSER 6000–3.0™ system weighs approximately 70 lbs. All lifting should be done using the handles
on the side of the unit with caution and assistance if available to prevent injury.
•If the pressure relief valve on the existing water heater tank is leaking or dripping, call a licensed
plumber for repair. Do not plug or remove valve as this could result in an explosion.
•Water temperature over 5ºF. (5ºC.) can cause severe burns instantly resulting in severe injury or
death. The GEYSER 6000–3.0™ is shipped at the default setting of 0°F. in accordance with Department
of Energy standards.
•Follow all safety instructions provided by the manufacturer of the existing water heater.
•The Geyser 6000–3.0™ must NOT be installed in location where it is exposed to temperatures of below
40°F. (4.5°C.) or above 0°F. (49°C.).
The Geyser 6000–3.0™ must NOT be connected to an electric water heater with heating elements larger
than 40 volt/5500 watts.