Northwestern Bell 76510-1 Owner's Manual - page 8
11159A-1 8
OWNER’S MANUAL #
PAGE #
3. Connect the opposite end of the
telephone line cord to the telephone
modular wall jack.
4. Align the wall mounting slots with
the studs located on the modular
wall plate and slide the base down
to lock in place. See figure 3
below.
(Figure 3)
NOTE: If you do not have a standard
modular wall jack, have a qualified
technician mount one on the wall.
Handset Retainer Tab Installation
If the base unit is to be placed in the wall
mount position, the handset retainer tab
must be pulled out, turned around and
placed in the opposite direction, so that
the tab allows the handset to hang onto
the base unit, as shown in figure 4.
(Figure 4)
OPTIONAL AC ADAPTER
POWER CONNECTION
CAUTION: Use only with Class 2
AC Adaptor with a rating of 120VAC
input, DC6V, 100 mA output with a
center tip that is negative. The adaptor
plug must correctly fit the unit’s DC
jack.
1. Plug the AC Adaptor into a standard
AC outlet.
2. Insert the small plug into the DC
jack on the rear of the base.
NOTE: THIS IS AN OPTIONAL
ACCESSORY THAT IS NOT
INCLUDED. PLEASE SEE THE
ACCESSORY ORDER FORM FOR
ORDERING INFORMATION.
CALLER ID OPERATION
Setting the Language Mode
After the battery installation and power
connection, the LCD panel will display
“E F S”
where, E = English
F
= French
S
= Spanish
1. Press either the REVIEW ► or ◄
button to select the desired
language.
2. Press the DELETE button to
confirm, and then display will
change to show “set area code.”
Area Code Setting
1. Press
REVIEW
► or ◄ button to
select the correct digit.
2. Press DELETE button to confirm
and shift to the next digit.
3. Repeat steps 1-2 to set the next two
digits.
4. After the area code is completed,
press DELETE button again to
change the display to TIME/DATE
setting.
Handset
Retainer
Clip