Nothern Industrial Tools 15891 User Manual - page 4
Page: 4 of 7
•
Disconnect air supply from tool and place the switch in the locked or off position before
making any adjustments, changing accessories, or storing power tools.Such preventive
safety measures reduce the risk of starting the power tool accidentally.
•
Secure work with clamps or a vise instead of your hand to hold work when practical. This
safety precaution allows for proper tool operation using both hands.
•
Store idle tools. When tools are not is use, store them in a dry, secure place out of the
reach of children. Inspect tools for good working condition prior to storage and before
re-use.
•
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may create a risk of injury when used on
another tool.
•
Keep guards in place and in working order.
•
Never leave tool running unattended.
•
USE COMPRESSED AIR ONLY. Use clean, dry and regulated compressed air at no more
than 90 PSI to power this tool. Never use oxygen, carbon dioxide or any other bottled gas
as a power source for this tool.
•
Use proper size and type air pressure line and fittings. The recommended air line for
this tool is 3/8" delivering no more than 90 PSI. Recommended air inlet size is 1/4".
•
Make sure the hose is free of obstructions or snags. Entangled hoses can cause loss of
balance or footing.
Note: Performance of the compressor (if powered by line voltage) may vary depending
on variations in local line voltage. Extension cord usage may also affect tool
performance.
Additional Safety Warnings
•
Repetitive motions or exposure to vibration may be harmful to your hands and arms.
•
When wearing gloves to operate the Horizontal Sander, make sure that the gloves do not
interfere with operating the trigger. Test your gloves with the trigger before attaching the unit
to an air source.
•
Never start the tool unless you have a firm grip with both hands and you are positioned at
your workpiece or area.
•
Before using the Horizontal Sander, know what is directly underneath the work area or
workpiece.
•
The Horizontal Sander can quickly penetrate material. If working directly on the ground,
make sure you are not directly above shallow cables, lines, or pipes.
•
Never point the tool or the air hose (not included) at anyone.
•
Keep your finger away from the trigger until you are ready to work.