Nothern Industrial Tools 15891 User Manual - page 5
Page: 5 of 7
Operation
Set Up
Fig. 1
1. You will need to prepare a 1/4" air connector (sold separately) to connect to the Air Inlet.
First, wrap the 1/4" air connector (not included) with pipe thread seal tape before
connecting to a Air Source Hose (not included).
2. Attach air hose to the Air Inlet on the Horizontal Sander. Note: If you are not using an
automatic oiler system, before operation, add a few drops of Pneumatic Tool Oil to the
airline connection. Add a few drops more after each hour of continual use.
3. Set the air pressure on your compressor to 90 PSI. Do not exceed the recommended air
pressure of 90 PSI.
4. Check the air connection for leaks.
5. Turn off the compressor and disconnect the air source hose in preparation to add wheels to
the Horizontal Sander.
MAINTENANCE
WARNING:
Make sure this tool is disconnected from its power source before attempting
any maintenance, cleaning, or inspection.
•
Maintain your tools.
It is recommended that the general condition of any tool be examined
before it is used. Keep your tools in good repair by adopting a program of conscientious repair
and maintenance in accordance with the recommended procedures found in this manual. If any
abnormal vibrations or noise occurs, turn the tool off immediately and have the problem
corrected before further use. Have necessary repairs made by qualified service personnel.
•
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control. Keep handles dry, clean, and free from oil
and grease.
•
Cleaning.
Use only soap and a damp cloth to clean your tools. Many household cleaners are
harmful to plastics and other insulation. Never let liquid get inside a tool.