Nova 5060 Owner's Manual - Foot Rest Assembly
FOOT REST ASSEMBLY
INSTALLING LEG REST
1 - Hold the foot assembly in position as if it were in position for use.
2 - Turn the front foot assembly to the side (so that open foot plate, which was perpendicular to the wheel,
is now parallel with the wheel).
3 - Slightly raise the assembly and place the hinge plates on the front foot assembly onto the hinge pins
on the product frame.
4 - Rotate the foot assembly inward, toward the inside of the wheelchair until it locks into place (so that
the foot plate is perpendicular with the wheel).
5 - Repeat for other foot assembly.
REMOVING LEG REST
1 - Push the release lever inward.
2 - Rotate the front foot assembly to the side (so that open foot plate, which was perpendicular to the
wheel, is now parallel with the wheel).
3 - Slightly lift the foot assembly so that it comes off the hinge pins.
ADJUSTING LEG REST HEIGHT
1 – RELEASE the tension screw by turning counter clockwise
2 - PRESS the leg rest release push buttons.
3 - Adjust the leg rest to the proper height.
4 - Ensure that the leg rest release button re-engages (push-buttons click in place).
5 – TIGHTEN tension screw by turning counter clockwise
SEAT
ADJUSTING SEAT HEIGHT
DO NOT ATTEMPT – Please see a dealer or qualified technician.
Any adjustment in your product seat can affect the stability of your product. We HIGHLY recommend that
you have a dealer or licensed technician adjust your seat height to ensure that your adjustments are safe
given your condition, and your product. Seat adjustments affect other parts of your product, including
without limitation, the adjustment of your anti-tipping supports, the necessary size and position of your
forks, the necessary size and position of your rear wheels, and the size and position of safety devices,
such as straps, locks, etc.
If you raise your seat height YOU MUST purchase proper anti-tipping supports. If your product came with
anti-tipping supports, then they are not likely to work with your new seat adjustment, and you must buy
new, proper supports.
REPLACING SEAT UPHOLSTERY
1 - The seat upholstery is held in place by eight Philips screws and washers, attached to the horizontal
bars on the product seat.
2 - Remove the screws, replace upholstery, and reattach screws.
REPLACING BACK UPHOLSTERY
1 - The back upholstery is held in place by eight Philips screws and washers attached to the upright bars
on the product back.
2 - Remove the screws, replace upholstery, and reattach screws.