Nova 5060 Owner's Manual - Anti-Tipping Supports
ANTI-TIPPING SUPPORTS
We recommend that you use anti-tipping supports to enhance the safety of your product. If your product
did not come with anti-tipping supports, and safety is your concern, then consider purchasing this
additional item.
INSTALLING ANTI-TIPPING SUPPORTS
Specific anti-tipping supports are only useful with certain seat angles and heights. If you cannot properly
adjust the anti-tipping supports given your seat angle or seat height, then DO NOT use product - contact
a dealer or technician.
1 – Remove the rear frame tube cap
2 - PRESS the adjustment release pin on the anti-tipping support.
3 - Insert anti-tipping support into the tube (wheel facing downward, toward the floor) until the brass pin
locks into place
4 - Place the product upright on a flat surface.
5 - Anti-tipping supports should be 1 ½ to 2 inches off floor, or they must be adjusted to this height.
ADJUSTING ANTI-TIPPING SUPPORTS
1 - Place the product on a flat surface.
2 - PRESS the tip length adjustment button (near the tip of the support).
3 - Adjust the support length to achieve 1 ½ inch to 2 inch clearance between the anti-tipping support and
the surface.
4 - Ensure that the anti-tipping support is locked in place at desired length.
5 - If you cannot properly adjust length of the anti-tipping supports, then you do not have the correct
supports for your product – contact the dealer who sold you the anti-tipping supports and obtain correct
supports for your product.
REVIEW
THE MOST RECENT DOCUMENTATION
INCLUDING
PRODUCT TERMS AND CONDITIONS
AT