Novac NV-ST3810XU User Manual - page 27
3. Windows will find “USB 2.0 Device” and the “Add New Hardware Wizard” dialog box
appears, click Next to continue.
fo
x, and click Next.
rive.
ox and then click Next. A screen
hould appear as the figure shown alongside. Make sure the
s found is driver. Click Next to continue.
. After the necessary files are copied, click Finish to
omplete this stage of installation.
ke
ette in floppy disk drive, click Next until
he figure.
. After the necessary files are copied, click Finish to
omplete the installation.
. Windows will complete the installation and can then detect the external drive. You will find a
new drive letter has been assigned for the drive in “My Computer”.
eck whether the devices are installed as the following:
ge
U
CDROM”.
4. On the following screen, select “Search for the best driver
r your device” bo
5. Insert the device driver diskette into floppy disk d
elect “Floppy disk drives” b
S
s
file that Window
6
c
7. Windows will then find another new device immediately,
ep the driver disk
Windows finds a driver and the screen appears as t
Make sure the file that Windows found is driver, click Next to
continue.
8
c
9
10. If the external drive doesn’t appear in “My Computer” or
doesn’t work properly, please go into “Device Manager” to
ch
USB2.0-ATA/ATAPI Brid
Controller: Installed under
“Universal Serial Bus Controller”
SB2.0-ATA/ATAPI Mass Storage Controller: Installed
under “Hard Disk Controller”.
he real name of the external drive: Installed under
T
“
How To Disconnect The External Drive From Computer
1. Click on the icon
on system tray and a dialog box appears beside this icon.
2. Click “Stop USB2.0 ATA/ATAPI Mass Storage Controller” in the dialog box.
3. Wait for few seconds until system prompts “The USB2.0 ATA/ATAPI Mass Storage
Controller can now be safely removed from the system”, click OK and then remove the USB
cable from computer.