Novar Lingo SE Installation Instruction - page 3
Step
Procedure
1
Remove the baseplate’s cover.
§
Use the hex wrench included with the baseplate to loosen the
two screws at the bottom of the baseplate.
§
Lift off the cover.
2
Position the baseplate against the wall.
3
Mark the wall to show the locations of the four slotted mounting
holes in the corners of the baseplate.
4
Drill holes in the places marked on the wall.
5
Install the hollow-wall or other appropriate fasteners.
6
Turn appropriate screws into the fasteners until approximately
one-quarter inch remains between the wall and the head of the
screws.
7
Position the baseplate over the screws and slide it down until the
screws slide into the slots.
8
Tighten the screws to secure the baseplate.
DOC. #569066200—C 8/17/06
3
Lingo
®
SE Baseplate Installation Instructions
Figure 1. Lingo SE baseplate mounting holes