OAKWORKS Antigua Instruction Manual - page 13
Double articulating action provides nearly limitless positioning options
with the QuickLock
™
Face Rest.The adjustable pad takes pressure off
sensitive facial areas while providing superb support. The QuickLock
™
Face Rest can be used in both prone and supine positioning and folds
out of the way when not in use. Adjustments are made easily by loosening
the cam locks, adjusting for height and angle and then locking the cam
locks into that position. The
Antigua
™
has outlets at the head of the
table for a variety of uses and outlets at the other end that work as well
for additional procedures.
Attaching the QuickLock
™
Face Rest / Head & Foot End Outlets:
When attaching the QuickLock
™
Face Rest to the head or foot end by
using the provided outlets, just slide the frame dowels into the outlets
being sure to keep the 1st cam lock within 3" of the table to ensure a stable
connection.
To remove the QuickLock
™
Face Rest, just pull the frame from the outlet
until it comes free. Set it safely aside or store it inside the under-table
cabinet until needed.
3"
ADJUSTING HEIGHT OF THE TABLE:
The O
AKWORKS
®
Antigua
™
comes complete with a multifunctional hand
control that operates the backrest and leg rest positioning functions as well
as a foot control that operates the height with ease.
Foot Controls:
Operate the foot control as shown below to raise or lower the height
of the Antigua
™
. The foot control allows the therapist to adjust the
height function separately from the other functions found on the hand
control whenever needed. When operating the table’s controls, be sure
to observe all cautions and warnings as given in the manual.
Hand Control: 4 positioning Buttons
The Hand Control on the
Antigua
™
operates all the customizable positioning
of the backrest, seat and leg rest of the top. Follow the directions on
the next two pages to access these functions.
5
DIRECTIONS FOR USE
• Adjusting Height and T ilt Angle
of the
Antigua™
using the Foot Control
DIRECTIONS FOR USE
Foot Control (1):
(used only to change height of table)
UP
To move the table
position higher, press
down on the left
side of the foot
control
To move the table
position lower, press
down on the right
side of the foot
control
DOWN
Antigua™
When operating the
Antigua™
controls be
sure to observe all cautions
and warnings given in the
manual to prevent injury to
both operator and client.
CAUTIONS
When operating the
Antigua
™
controls and making
any and all adjustments to the
table, move hands, feet and
controls away from any work-
ing mechanisms of the table.
Children must be supervised
when around this equipment by
a responsible adult. Do not
leave children alone or allow
them to operate the controls.
Do not allow children to crawl
into the cabinet or under the
table.
DIRECTIONS FOR USE
• Foot Control
CAUTION
DO NOT use the hand
control and the foot control
simultaneously as this can
cause damage to one or
both units.
IMPORTANT
* U.S. Patent #5,177,823
CAUTION
Do not put excessive weight
or pressure on the face rest.
Excessive pressure can cause
premature failure of the
QuickLock
™
Face Rest.
QuickLock
™
Face Rest
Important Safety Note: Maximum
Distance from edge of table = 3"
Important Safety Note: Maximum
Distance from edge of table = 3"
Be sure to read all
cautions, warnings
and instructions given
in the manual to prevent
injury to both operator
and client.
QuickLock
™
FACE REST:
• Accessory Option:
QuickLock
™
Face Rest
DIRECTIONS FOR USE
IMPORTANT
12
ACCESSORY OPTIONS
• QuickLock
™
Face Rest
ACCESSOR
Y OPTIONS
outlets