Oasis 032725-005 Installation and service manual - page 3
031666-009 Rev C 2000
Page 2 of 11
INSTALLATION STEPS
PREPARATION
Check this list to ensure that all appropriate parts
are packed with your system. See Page 4 for a
complete parts breakdown.
Determine approximate location for installation of
system: Filtration unit, saddle tapping valve and
reservoir.
LOCATION OF RESERVOIR
The reservoir is placed within the unit. Tubing
length between components should be kept to a
minimum, avoiding sharp bends or kinks.
LOCATION OF FILTRATION UNIT
Filtration Unit may be installed in any convenient
location. The unit must be within 15 feet of the
source water supply and other Point-Of-Use
systems if applicable.
Do not place unit where it will be exposed to
freezing and/or direct sunlight.
Figure 1 Component and Interconnection Locator