OBaby Apollo Instruction Manual - page 5

Fitting and Removing the Hood

Adjusting the Hood

fig. 24

fig. 27

fig. 25

fig. 28

fig. 26

fig. 29

To fold the hood, pull the hood adjusters up on both sides of the hood, as shown above.

fig. 30

fig. 33

fig. 31

fig. 34

fig. 32

fig. 35

Using the Harness

Press

To fit the hood, place the hood on the chassis, inline with the seat unit. Clip the hood 

catches onto each side of the chassis (fig.24 & 25).

Then to prevent the hood slipping down pull the elastic around the chassis and loop over 

the peg on the side of the hood (fig.26).

To remove the hood, do the reverse of the above.

Waist

Strap

Crotch

Strap

Shoulder

Strap

Clasp

fig. A

Harness 

Positions

Lower

Inner

Inner

Outer

Outer

Outer

Upper

To fasten the harness, insert each waist strap fastener 

through the loop on each shoulder strap (fig.30). Then 

insert both waist strap fasteners into the clasp on the 

crotch strap (fig.31 & 32).

To release the harness, squeeze each of each clips in the 

centre of the harness and pull away from the clasp, one at 

a time (fig.33).

Adjust the harness length using the buckles on each strap 

(fig.34).

‘D’ Ring 

The ‘D’ rings highlighted are provided for fitting a separate 

harness complying with BS 6684 (fig.35).

When using the safety harness from birth, it may be necessary to use the lower holes for 

the shoulder strap and the inner holes for the waist straps and crotch strap.

Higher holes for the shoulder strap and outer holes for the waist straps and crotch strap 

should be used when your child is of a suitable size. (See fig.A)

WARNING: 

Always use the crotch strap in combination with

the waist belt

www.obaby.co.uk

www.obaby.co.uk

8

9