OBaby Chase 4 Wheeler Pramette Instruction Manual - page 7
Using the Carrycot
Fitting the Car Seat on the Chassis
To convert the stroller into the pram, first recline the backrest (fig.47) (see page 9 for
details).
Then press the buttons on either side of the seat unit (fig.48) and tilt the seat until it is
flat (fig.49).
Unclip the clasps behind the footrest, then push the footrest down until it is flat
(fig.50 & 51).
Remove the bumper bar (see page 7 for details) and add the carrycot liner and apron if
required.
The seat unit can also be turned around to face the opposite direction (see page 9 for
details).
To put the car seat onto the chassis, first remove the stroller seat unit (see page 9 for
details).
Then fit the car seat adaptors to the chassis (fig.53 & 54) ensure the realease levers are
towards the front wheels.
Lower the car seat onto the adaptors (fig.55), ensure it clicks into place on both sides
(fig.56).
To remove the car seat from the chassis, either press the release buttons on either side
of the car seat and lift the car seat up, away from the adaptors (fig.57), or press the
release buttons on either side of the car seat adaptors and lift the car seat and adaptors
up, away from the chassis (fig.58).
fig. 47
fig. 53
fig. 56
fig. 50
fig. 48
fig. 54
fig. 57
fig. 51
fig. 49
fig. 55
fig. 58
fig. 52
“Click”
“Click”
“Click”
Lift
Press
Lower
Lift
WARNING:
Ensure that all locking devices are engaged before use
12
13
www.obaby.co.uk
www.obaby.co.uk