OBaby mercury Instruction Manual - page 5

Fitting and Removing the Hood

Adjusting the Hood

fig. 24

fig. 27

fig. 25

fig. 28

fig. 26

fig. 29

The hoods are independently adjustable.

To open or close the hood, pull or push the hood as shown above. (fig.27-29)

fig. 30

fig. 33

fig. 31

fig. 34

fig. 32

fig. 35

fig. A

Using the Harness

Press

‘D’ Ring

To fit the hood, place the hood on the chassis, inline with the seat unit. Locate the peg on 

each side of the chassis and clip the hood on, over each peg (fig.24). Secure using hook 

and loop tape around chassis (fig.25).

To remove the hood, lift to release the clips (fig.26).

Waist

Strap

Crotch

Strap

Shoulder

Strap

Clasp

Harness 

Positions

Lower

Inner

Inner

Outer

Outer

Outer

Upper

To fasten the harness, insert each waist strap fastener 

through the loop on each shoulder strap (fig.30). Then 

insert both waist strap fasteners into the clasp on the 

crotch strap (fig.31 & 32).

To release the harness, squeeze each of each clips in the 

centre of the harness and pull away from the clasp, one at 

a time (fig.33).

Adjust the harness length using the buckles on each strap 

(fig.34).

‘D’ Ring 

The ‘D’ rings highlighted are provided for fitting a separate 

harness complying with BS 6684 (fig.35).

When using the safety harness from birth, it may be necessary to use the lower holes for 

the shoulder strap and the inner holes for the waist straps and crotch strap.

Higher holes for the shoulder strap and outer holes for the waist straps and crotch strap 

should be used when your child is of a suitable size. (See fig.A)

WARNING: 

Always use the crotch strap in combination with

the waist belt

8

9

www.obaby.co.uk

www.obaby.co.uk