OBaby Monty Instruction Manual - page 7

Fitting and Removing the Play Tray

Adjusting the Hood

fig. 25

fig. 28

fig. 26

fig. 29

fig. 27

fig. 27a

fig. 30

To adjust the hood, simply lift or lower the hood to the desired position (fig.28-30).

fig. 31

fig. 34

fig. 32

fig. 35

fig. 33

fig. 36

Using the Harness

Press

To fit the play tray, hold the play tray upright and slide 

the locating pin into the receiver facing up on the chassis 

(fig.25).  Rotate the play tray around using the locating pin 

as a pivot.  Press the button underneath the play tray and 

lower into position on the chassis (fig.26 & 27).

To remove the play tray, press the button underneath the 

play tray and lift the tray up (fig.26).  Rotate the play tray 

fully around using the locating pin as a pivot (fig.27a), and 

slide the play tray out.

Waist

Strap

Crotch

Strap

Chest

Strap

Clasp

To fasten the harness, insert both fasteners on the waist strap into the clasp on the 

crotch strap (fig.31) and clip each chest strap onto the waist strap (fig.32 & 33).

To release the harness, press the button in the centre of the clasp and remove the waist 

strap fasteners (fig.34).

Adjust the harness length using the buckles on each strap (fig.35).

‘D’ Ring 

The ‘D’ rings highlighted are provided for fitting a separate harness complying with BS 

6684 (fig.36).

WARNING: Ensure the harness is correctly fitted before use.  The harness should 

always be adjusted to fit correctly.  Children should be harnessed in at all times.  

Always use the crotch strap in combination with the waist strap.

1.Press

2.Lower

12

13

www.obaby.co.uk

www.obaby.co.uk