OBaby Monty Instruction Manual - page 9

Removing the Car Seat from the Chassis

fig. 46

fig. 47

fig. 48

Adjusting the Car Seat Handle

The car seat handle has 3 positions:

Fig.46 - For carrying your child or fitting in the car

Fig.47 - When fitted on the stroller or for rocking your baby

Fig.48 - When used as a seat, eg. for feeding

To adjust the handle position, press the handle release button on either side of the car 

seat and turn the handle to the required position, release the buttons.  Check the handle 

has clicked into place.  Always check that the handle is locked and the harness fastened 

before lifting the car seat.

fig. 43

fig. 44

fig. 45

To remove the car seat, first rotate the handle to the upright position by pressing the red 

button on either side of the car seat.

Lift the release catch underneath the car seat (fig.44) and lift the car seat away from the 

chassis (fig.45).

Lift

Lift

fig. 49

fig. 52

fig. 50

fig. 53

fig. 51

fig. 54

Using the Car Seat Harness

Press

1.Press

Pull

2.Lift

Crotch

Strap

Chest

Strap

Clasp

To fasten the harness, overlap the fasteners on the chest straps (fig.49) and clip into the 

clasp on the crotch strap (fig.50 & 51).

To release the harness, press the button in the centre of the clasp and remove the chest 

strap fastners (fig.52).

To slacken the harness, press the harness release button then lift the chest straps 

(fig.53)

To tighten the harness pull on the harness strap as shown (fig.54).

WARNING: Ensure the harness is correctly fitted before use.  The harness should 

always be adjusted to fit correctly.  Children should be harnessed in at all times.  

Always use the crotch strap in combination with the waist strap.

16

17

www.obaby.co.uk

www.obaby.co.uk