OBaby zeal Instructions Manual - page 12

Fitting the Car Seat on the chassis

To put the car seat onto the chassis, first fully recline the backrest on the stroller

(see page 7).

Then fit the car seat adaptors to the chassis, ensure the release levers are towards 

the front wheels and locate the securing lever over the peg on the chassis (see arrow) 

(fig.76). Clip into place with the lever (fig.77).

Lower the car seat onto the adaptors (fig.78), ensure it clicks into place on both sides 

(fig.79).

To remove the car seat from the chassis, either press the release buttons on either side 

of the car seat and lift the car seat up, away from the adaptors (fig.80-81), or remove 

the car seat adaptors from the chassis (fig.77) and lift the car seat and adaptors up, 

away from the chassis.

fig. 76

fig. 79

fig. 77

fig. 80

fig. 78

fig. 81

“Click”

“Click”

Lift

Lower

WARNING:

 Ensure that all locking devices are engaged before use

23

22

www.obaby.co.uk

www.obaby.co.uk