OBaby zeal Instructions Manual - page 9
fig. 49
fig. 52
fig. 55
fig. 50
fig. 53
fig. 56
fig. 51
fig. 54
fig. 57
Assembling the carrycot
To assemble the carrycot, first unzip the three zips on the outer sides of the carrycot.
(fig.49).
Then insert the two side boards on the left and right of the carrycot, ensure the wider
end of the board is towards the head of the carrycot and the chassis clasp is on the
outside (fig.50 & 51).
Feed the chassis clasp straps through the slot in the fabric (fig.52).
Insert the top board (note: this is the larger of the two boards) in the slot at the head of
the carrycot (fig.53).
Insert the bottom board (note: this is the smaller of the two boards) in the slot at the
foot of the carrycot (fig.54).
Then insert the rods into both the head and the foot of the carrycot (fig.55). Be sure to
feed the rods into the pocket at either side of the carrycot (fig.56). Secure the rods in
place with the hook and loop tape (fig.57).
Zip up the three zips (fig.49).
fig. 58
fig. 59
fig. 60
Attach the apron to the carrycot shell using the zip (fig.58). Secure the top of the apron
in place with the hook and loop tape and press stud on either side (fig.59 & 60).
16
17
www.obaby.co.uk
www.obaby.co.uk
Assembling the carrycot
Using the apron