OBH Nordica 6035 Instruction Manual - page 20
20
13. For additional protection the installation of a residual
current device (RCD) with a rated residual operating current
not exceeding 30 mA is recommended. Ask your installer for
advice.
14. The appliance is for domestic use only, and must not be
used professionally or medically, since the appliance is not
included in the CE directive concerning electro-medical
appliances.
15. If the appliance is used for other purposes than intended, or
is it not handled in accordance with the instruction manual,
the full responsibility for any consequences will rest with
the user. Any damages to the product or other things are
not covered by the warranty.
Please read the instruction manual carefully before use and save it for later
reference.
Massage has a relaxing effect on the body. It also can work as a preventive
measure and is used in coordination with beauty care.
Use
Plug in the cord. Make sure that the switch is in off position. Start the appliance
by sliding the switch to the desired position.
0
The appliance is turned off
M Massage
V
Infrared light
VM
Combined infrared light and massage
If the switch is in position “V” or “VM”, the appliance needs 8-10 minutes to get
warm.
Test the temperature of the massager with the palm of your hand to make sure
that the desired temperature is reached. If the appliance has been on for more
than 10 minutes in position “V” or “VM”, make sure that the massager is not to
warm. The temperature can be adjusted by switching off the heat for shorter
periods of time.
The handle of the massager can be adjusted for best massaging position. Simply
press the circular button in the middle of the handle, hold it while you are adjusting
the angle of the handle. Release the button upon reaching the desirable angle.
6035_ES_UVN_040713.indd 20
7/5/2013 12:05:37 PM