Oce Arizona 550 GT User Manual - page 16
ducing combustion-related pollution. Using the energy management features outlined
below prevents unnecessary power consumption, which helps to prevent air pollution
from electricity generating plants and saves money on your utility bills. As an ENERGY
STAR® Partner, Océ has determined that Océ ColorWave 550 meets the ENERGY
STAR® criteria for energy efficiency laid down in the ENERGY STAR ® Program Re-
quirements for Imaging Equipment (Version 1.2)
Energy consumption (All countries)
In order to limit energy consumption during times of non-use the Océ ColorWave 550
has a Sleep mode during which the power level is reduced. The value for the Sleep mode
is listed in the Product Safety Data Sheet.
Power modes and delay times
The energy consumption and efficiency are influenced both by the product technology
and by the settings chosen by the user, especially the delay times that are selected to enter
reduced power states. The following delay times have been pre-set.
Power modes and delay times
#
Default delay time (minutes)
Operational mode
1 minute (range 1 - 60 minutes)
Low power
30 minutes (range 15 - 240 minutes)
Sleep
The modes above are automatically entered after the Default Delay Time has elapsed;
counting from the moment the last print has been produced. These settings are recom-
mended and for most users ensure both ease of use and low energy consumption. Between
brackets are the minimum and maximum values. The Delay Times can be changed.
Shorter delay times will reduce energy consumption even further, but may cause longer
recovery times. In some cases longer delay times may prove to be more convenient, but
it should be noted that this may cause an increase in energy consumption. Therefore,
from an energy preservation point-of-view, longer delay times are not recommended.
Standby power (Federal Energy Management Program) (all countries)
This product meets the following criteria for the United States Federal Energy Management
Program (FEMP):
• In Standby mode, this product consumes less than 1 W. After shutting down all systems
properly, Standby mode as defined by FEMP is reached by setting the main switch
to "0".
• This product has a hard-off switch.
Chapter 2 - Regulation notices
16
Regulation notices