Oce CS6407 Basic Operation Manual - page 34
Océ 6407 Basic Operation Guide
34
3
Capping unit side
Wiping unit side
Knob screw
Flange holder
Shaft holder
Remove the fl ange holder, and open the shaft
holder.
To open the shaft holder, loosen the knob screw.
4
Printer rear
Load the media roll into the Printer’s rear side
(supply side).
CAUTION
- As the media is heavy, carefully carry it with a recommended dolly.
- On carrying the media with two persons, carefully carry it by manually holding the scroller shaft.
- Be careful not to catch your fi nger or hand between the Printer and the scroller shaft.
Recommended dolly
Scroller shaft
On carrying the media alone:
On carrying the media manually by two persons:
5
Capping unit side
Wiping unit side
Knob screw
Flange holder
Shaft holder
Set the fl ange holder, and close the shaft holder.
After closing the shaft holder, fasten the knob screw.
6
Front cover
Protection bar
Remove the protection bar and open the front
cover.