Oce CS6407 Basic Operation Manual - How to Clear Media Jams
75
Introduction
For your basic operation
Maintenance
When encountering a problem
Appendix
If the printer reports a media jam, follow these steps.
1
W A R N I N G ! X
C L E A R M E D I A J A M
X: Media jam type
Meaning
0: Media jam 0
A jam on the media feed path is invalidating the Printer's normal operation.
1: Media jam 1
A jam on the carriage is invalidating the Printer's normal operation.
2: Media jam 2
The media was not detected correctly because:
- Roll media or cut-sheet media was selected incorrectly.
- The length of the applied cut-sheet media is not as prescribed.
The message appears.
2
Pressure control knobs
Take-up side
O P E N C O V E R
R E M O V E M E D I A
Rotate the pressure control knob, and set it to
“Open”, and then open the front cover.
3
Remove the jamnned media, make sure that no obstruction is left in the carriage path and the
media feed path, and then close the front cover.
At manually sliding the carriage...
- If the carriage must be moved manually, slide
the carriage by softly pressing the arrowed
parts.
4
C A R R I A G E M O V I N G
P L E A S E W A I T
Close the front cover.
The carriage moves to the home position.
5
Again load the media on the Printer.
See "To load media on the Printer" on page 32.