Oce im5530 User Management Manual - page 21
Setting up User Management Setting 19
6
Enter the following items and click [Next].
Domain Name — Enter the domain name in your network.
PDC — Enter the server name or IP address of the Primary Domain Controller.
BDC — Enter the server name or IP address of the Backup Domain Controller as you
required.
y
If the wrong primary or backup domain controller is specified, the [ENTER] button in
the USER AUTHENTICATION screen on the touch panel is highlighted while this
equipment searches for the primary or backup domain controller for 2 to 4 minutes.
In that case, correct the primary or backup domain controller setting after the beep
will sound and the alert message will be displayed on the touch panel.
y
You can specify up to 3 domain names. You must specify at least one domain name
to enable the Windows Domain Authentication.
7
Specify the following items and click [Next].
Role Based Access — Select whether the Role Based Access Control is enabled or not.
LDAP Server — Select the LDAP server that manages the Role Based Access Control.
y
When you enable the Role Based Access Control, you must also configure the LDAP
server to manage the operation of this equipment using Role Based Access Control.
For instructions on how to configure the LDAP server for Role Based Access Control,
please see Network Administration Guide.
y
The LDAP server to be used for the authentication must be configured in the Direc-
tory Service submenu page in the Maintenance menu. When you configure the
Active Directory in Windows server, please specify the domain administrator or
account operator for the user name.