Oce TDS750 User Manual - page 8
conditions, immediately turn OFF the power switch and unplug the power cord from
the power outlet. Then call your authorized service representative.
• Do not use an extension lead to connect the machine.
• Only use the mains connector cable that was supplied with the machine.
Power source
Warning
• Put the power plug directly into a wall socket that has the same configuration as the
plug. The use of an adapter leads can result in an inadequate power supply. If a
proper wall outlet is not available, ask a qualified electrician to carry out the installation.
• Do not connect the machine to a mains voltage that differs from the value as stated
on the power marking label.
• Do not use a multiple outlet adapter or an extension lead. Contact your authorized
service representative if an extension lead is required.
Caution
• Consult your authorized service representative before you connect other equipment
to the same wall outlet.
Note
• If connection to a different mains voltage is required, contact your authorized service
representative.
Power plug
Warning
• For machines that are connected via a wall socket: Place the machine close to a wall
socket that is easily accessible. The power plug is intended to serve as a disconnect
device.
Grounding
Warning
• Connect the power cord to an electrical outlet (wall socket) that is equipped with a
grounding terminal.
• This equipment has not been designed for connection to an IT power system. An IT
power system is a voltage network in which the neutral wire is not connected to ground.
Installation
Warning
• Make sure that the machine is placed on a level, horizontal surface of sufficient strength.
• Make sure that the machine stands on its feet so all four wheels turn freely.
• Do not place this machine on an unstable or tilted bench.
• Do not place this machine in a location that is subject to lots of vibrations and shocks.
Chapter 1 - Instructions for safe use
8
Instructions for safe use