OCEAN PRESENCE AquariCamOPT-12HD User Manual - page 4
AquariCam OPT-12HD User’s Manual
Version: 5/29/13
Ocean Presence Technologies
Copyright ©2010-2013
Page 4
SHIPPED COMPONENTS
1.0
QUICK START
The AquariCam Underwater IP camera
system (UWIP) has been designed to
simplify installation and deployment.
1.1 C
ONFIGURING THE
N
ETWORK
The AquariCam is ready to be used out of
the box and is network ready. Configuration
software is included in the Installation CD
and should be downloaded and installed
into a Windows computer.
The AXIS P1357 can be used with most
standard operating systems, and supports
Microsoft Internet Explorer 5.x or later,
Netscape 7.x or later and Mozilla 1.4 or
later.
The standard system includes a power
supply and an underwater Power-over-
Ethernet (PoE) cable. The PoE connector
should be attached to the housing and the
cable stress relief sleeve lightly tightened.
To connect to the network, attach the other
end of the PoE cable to the OUT port of the
power supply. A standard Ethernet cable
can then be attached from the IN port of the
power supply to a router, computer or
Internet modem.
Once all network cables have been
attached, you can apply power to the
system. This begins the camera “booting”
process taking about a minute. To install the
camera on your computer, insert the install
disk and download the Axis IP Utility. Once
it is installed, the camera and its IP address
will become visible.