Ocean Reef NEPTUNE SPACE PREDATOR Owner's Manual - page 10
Neptune Space Predator Manual rel 2.3 December 2008
10
QUICK STEPS
1. BEFORE DIVING
Don the mask (make sure surface air valve or octopus port is open to
allow air in).
Adjust the straps and test equalization.
Remove mask and adjust equalization system, if needed (see diagram
on this card).
Connect to 1st stage & tank. Open the tank valve slowly while pressing
the purge button of the 2nd stage and check that the air flows freely.
Release the button and check that air stops flowing.
2. DURING A DIVE
Before submerging, push the aspiration knob to DIVE position “+”.
Close surface air valve before descending.
Breathe normally through your nose or mouth, whichever is most
comfortable.
If water gets inside the mask, push the purge button while facing
straight ahead.
To equalize, press the top part of the mask visor.
3. AFTER DIVING
Carefully rinse the regulator with fresh, gently flowing water. Do not
press the purge button.
Make sure the dust cover is firmly in place to keep water out of the
first stage
Attach the regulator to the tank after rinsing and press the purge
button for 10-15 seconds to purge any water or debris from regulator.
When storing equipment, do not tightly loop the hoses and avoid
pulling on them when the regulator is attached to the tank. Do not
bump the Neptune Space. If you do, check for any damage.
When storing the mask turn counterclockwise the adjustment knob.
Ocean REEF highly recommends that you practice in a pool before using
your mask in open water.
2.
1.
4.
5.
6.
3.
*Note the position of the strap in relation to the head (see left).