Ocean Signal PLB1 User Manual - page 11
PLB1 USER MANUAL
11
Version 01.03 23/10/2017
5.
APPENDIX
5.1
Maintenance and Troubleshooting
Your PLB will require little maintenance except periodic cleaning, if required. Always use
a damp cloth to clean the case and dry thoroughly. Do not use solvents or other cleaning
fluids as this may cause the plastics to deteriorate. Ensure the antenna is free to unwind.
5.2
Batteries
The PLB1 contains Lithium batteries for long operating life. Your battery must be replaced
either after the expiry date or after the PLB has been activated, even if only for a short
period of time. Battery replacement must be done at an Ocean Signal authorised battery
replacement centre.
5.3
Transport
When shipping your PLB the following guidance and regulations should be followed, but
you are advised to contact your nearest battery replacement centre or Ocean Signal prior
to shipping as regulations may have changed. The PLB1 battery contains <2g of lithium.
•
Always pack your PLB securely in a stout cardboard carton. Ocean Signal advises that
you keep the original packaging in case of return for service.
•
For surface transport the PLB may be shipped ‘excepted’ under special provision 188.
•
For air transport the PLB should be shipped as category UN3091 and packed under
IATA packing instruction 970 section II. If you are hand carrying your PLB on an aircraft
please contact your airline for advice.
5.4
Disposal
Care should be taken when disposing of your PLB when it is no longer required. It is
recommended to remove the battery from the PLB by removing the case lid. The case
screws are covered by the top label. Dispose of the battery in accordance with local waste
regulations. Please note that the PLB1 is not user serviceable and removing the lid will
invalidate the warranty.