Ocean Signal rescureME MOB1 User Manual - page 6
MOB1 USER MANUAL
6
Part No 912S-01365
2.
Lifejacket Installation
If your rescueME MOB1 is not already pre-installed lifejacket, please follow the
instructions below carefully.
•
Loop the strap through the operating clip.
•
Clip the bracket to the MOB1 so that the MOB will be on the outside of
the inflation tube. The following diagrams assume that the mounting
is to the left of the inflation tube. On most occasions it is
preferable to mount to the outside of the tube.
•
Clip the MOB1 to the inflation tube
•
Wrap the strap around the life jacket. When looping the strap through the bracket,
make sure that the strap is not twisted. Tighten the strap when complete.
•
Mounting the MOB to the right. Follow steps 2-4 but swap over to the right. When
looping the strap through the bracket, make sure is has not twisted in the process.