Ocean Signal rescureME MOB1 User Manual - page 7
MOB1 USER MANUAL
7
Version 00.03 08/10/2014
•
Arm the MOB. Once the MOB is fully attached to the life-jacket, you are ready
to arm the device.
•
Testing
•
MOB Installation sticker
3.
MMSI configuration
3.1
Self Identification
The MOB1 is supplied with the self identification number pre programmed. This number is
specific to each MOB1 and cannot be changed. The MMSI displayed on the AIS receiver will
always start with ‘972’ irrespective of the country it was purchased in.
3.2
User MMSI
(Applies to DSC enabled units only)
To be able to send DSC messages to your vessel, the MMSI number of the vessel needs to
be programmed into the MOB. This is achieved using a PC based application and the PC
screen.
3.2.1
Installation
The programming software for the can be downloaded from
www.oceansignal.com/installers/MOBconfig.msi
Save the file to your computer and open it to run the installer. Follow the instructions on
screen.
3.2.2
Configuration
Run the application from the desktop icon. The screen shown will appear.
Select the Screen button.
Enter the nine digit MMSI of the vessel in the box provided
and select update beacon. After the MMSI has been