Octane Fitness LX8000 Assembly And Operation Instructions Manual - page 3
2
B. Wireless (800MHz/900 MHz) Receiver
Route receiver cable down through mast and
out the bottom of the mast (not pictured).
Center the receiver on the user side of
the frame bar that is between the moving
handlebars, making sure the wire antenna is
on the top of the receiver. Insert cable tie C-4
(Qty 2) through holes in receiver bracket and
secure bracket to frame.
Connect audio jack cable and receiver cable
to receiver. Secure loose cable to side of
frame bar with cable tie C-4 (Qty 2).
Remove slack from audio jack cable and
secure under keypad plate with cable tie C-3
(not pictured).
LX8000 WIRELESS AUDIO KIT ASSEMBLY INSTRUCTIONS
A.
Audio Jack
Remove bottom screw from water bottle
holder.
Connect audio cable to audio jack assembly
(not illustrated).
Loosen screws on audio jack assembly; place
assembly over mast plate; tighten screws.
Secure with screw to water bottle holder.
Remove upper left screw from water bottle
holder; insert C-1(Qty 1) through C-3 (cable tie);
re-attach to water bottle holder and tighten
screw. (Do not cable tie audio cable at this
time.)
Route audio cable down through hole under
keypad plate and out the bottom of the mast.
Complete these instructions during initial assembly of the LX8000 elliptical, after mounting the keypad on the
mast. For a fully-assembled LX8000, remove the top covers, console, keypad and CSAFE cable (connected to
CSAFE port on console back--see diagram on page 3), then complete these instructions. *Retain all screws
for use in this assembly.
Cables
not
shown
Cables
not
shown