Octane Fitness Q47ce Assembly Manual - page 10
10
i. Selectaprimarycontactplate(g)thatmatchesthecontour
ofthetopoftheplasticgrip(closesttoauser).Peelthe
blue protective film off of the tab on the primary contact
plate(g),thenslidethetabintotheconnectorattheend
of the small white wire.
j. Select a secondary contact plate (h) that matches the
contourofthebottomoftheplasticgrip(awayfromthe
user).Peeltheblueprotectingfilmoffofthetabonthe
secondary contact plate (h) and slide the tab into the
connector at the end of the remaining wire.
k. Repeatsteps(f)through(k)fortherighthandlebar.
l. Pushanyextralengthsofwireintothemasttube.
m. Insert the connector at the end of the heart rate cable into
itsconnectorontheheartrateboardonthebackofthe
keypad.(This is a two-wire cable ending in a single
connector.) Route the contact heart rate cable wires
aroundthepostsonthebackofthekeypad,inthesame
mannerthattheotherheartratecableisrouted(seefigure
at right).
n. Route the cable from the other end of the heart rate board
down through the top of the mast tube and out of the hole
beneath the console plate.
o. Route the red and white fan wires with the white connector
down through the top of the mast tube and out of the hole
beneath the console plate.
p. Attachtheblackribboncableconnectorfromthekeypad
(2) to its cable coming from the top of the mast. Tug
the cables gently to ensure the connectors are
completely seated.
q. Positionthekeypad(2)onthemast(B)andinserteachof
the 4 shorter screws with washers through the mast holes
andintothekeypadback.Tightenscrewstosecure.
r. Remove the film from the adhesives on the primary
contact plates (g) and secondary contact plates (h)
and carefully press the plates onto the grips, pushing
the tabs, connectors, and wires inside the grips.
It is recommended that you wait to adhere the grips
until after you have installed the console and verified
that the contact heart rate grips are transmitting a
reading to the console.
Console/Keypad
Connection
(all models)
Standard
Heart Rate
Connection—
Q47e/Q47ce only
Contact Heart Rate
Connection—
Q47ce only
Fan Wire—
Q47e/Q47ce only
Keypad Ground
Connection
(all models)
Route
Contact Heart Rate Cables
Here
Contact Heart Rate Board
Connector for
Grip Wire
Note: If you are using the optional LCD Mounting Arm,
skip step 6 of these instructions and instead follow the
instructions included with the LCD Mounting Arm. Once
you have completed those instructions, resume assembly
of your Q47e/Q47ce with step 7 of these instructions.