Octane Fitness Zero Runner 7 Operation Manual - Electronics
5
ELECTRONICS
The Octane Fitness ZR7 features a simple, easy to understand keypad and a dynamic display which provides all
the information you need to get started and stay motivated during your workout. You can program the software
to help you manage your workout (like you would your watch or training monitor), but the actual execution of the
plan is entirely up to you. The ZR7 does not automatically change or control motion or resistance, it simply guides
you with icons and timers to suggest varying intervals and movements. You are the athlete and the Zero Runner
is your coach and trainer.
Dynamic Display (LCD)
The LCD display dynamically displays all of the important workout data and guides your workout with intervals and
motion changes. Watch the display—it will coach and motivate you throughout your workout.
The following data is available on the display:
When illuminated, this indicates that the batteries in the console are getting low
and should be replaced. To replace the batteries, use a #2 Phillips screwdriver to
remove the console access cover. Remove the batteries and replace them with
new ones, making sure you insert and align the batteries according to the guide
embossed on the back of the console. Replace the console access cover, and properly
dispose of the old batteries.
(Large Time Display)
Displays workout time, counting up from 0:00. This display can be used simply as a
timer which starts automatically as soon as you start moving, or a desired workout
time can be set during your workout by pressing the clock (
) button on the keypad.
When you do so and enter a workout time, the time display changes from “count up”
to “count down” mode and shows the time remaining in your workout. When time is
displayed, the timer goes up to 59 minutes, 59 seconds (59:59), then the display rolls
over to 1 hour, 0 minutes (01:00) and begins counting in minutes instead of seconds
from that point forward.