Ocular RobotEye RE01 Imaging User Manual - 2.7.1 Replacement Parts
12
www.ocularrobotics.com
Ocular Robotics Pty Ltd
2.7 Cleaning and Maintenance
CAUTION – Power must be disconnected from the RE05 system
before any cleaning or maintenance is carried out.
User performable cleaning and maintenance of the RobotEye RE01 Imaging System is
limited to cleaning of the exterior housing and the aperture window. For ANY other
maintenance or repair the unit should be returned to the factory. Unauthorised opening
of the system enclosure will void warranty. Use the following guidelines for cleaning of
the system enclosure and aperture window.
It is VERY important not to abrade or scratch the system window during cleaning or
at any other time as it has the potential to significantly degrade system performance.
Use a soft non-abrasive cloth to clean the window, make sure there are no foreign
abrasive particles on the window before performing cleaning, as this may damage
the window.
DO NOT use solvents. If a cloth alone is not sufficient, water or Isopropyl Alcohol
may be used.
The rest of the RE01 Imaging system housing can be cleaned with a soft damp cloth.
2.7.1 Replacement Parts
Replacement parts can be ordered directly through Ocular Robotics.
1) RobotEye RE01 System power cable.
a) The power cable comprises of a standard 3 core power cable rated for at least
10A.
b) The power cable has an IP68/IP69K UTS6JC103S Souriau connector attached to
interface with the mating UTS6JC103P receptacle on the enclosure.
2) Cat5e/Cat6 Ethernet cable (RE01 System).
a) The Cat5e or Cat6 Ethernet cable can optionally be fitted with an IP68/IP69K
Souriau UTS6JC18RJN connector.
3) 5mmx20mm 16A Fuse (RE01 System).
a) The fuse is located in the Schurter Fuseholder located above the left Souriau
Ethernet connector.