ODG R-7 User Manual - Reticle Speed Mouse
15
RETICLE SPEED MOUSE
2D Mode
In 2D mode, you control the cursor by swiping your thumb on the Track
Pad. 2D mode is ideal for situations requiring fine-grained control of the
cursor, or in situations where you might be in motion, such as inside of a
moving vehicle.
3D Mode
In 3D mode, sensors detect the position of the mouse and the cursor is
controlled using simple hand movements much like a laser pointer. In 3D
mode you also can scroll up and down through some content such as a web
page or PDF file by swiping your thumb on the trackpad much like a scroll
wheel on a desktop mouse.
Note: 3D mode requires more power to operate, and the battery life may be
reduced with frequent 3D use. To switch from 3D to 2D mode, press and hold
both the Volume Down and Volume Up buttons at the same time for longer
than 3 seconds.
Switching Modes
To toggle between 2D and 3D mode, press and hold both the Volume Down
and Volume Up buttons at the same time for 3 seconds. The status light will
illuminate green when 3D mode is active.
Standby/Hibernate Modes
When the RSM is not in contact with the user’s finger and no buttons are
pressed it will enter Standby mode, increasing battery life, after 5 minutes.
If no contact or button presses are detected after 15 minutes it will enter
Hibernate mode. Placing the RSM on the user’s finger or pressing any button
will wake the device and cause it to re-connect with the glasses. In Standby
mode this happens instantly, while in Hibernate mode there will be a slight
delay of 2-3 seconds while the device awakes and re-connects.
Note: While in 3D mode (when status light is green), the RSM will not
enter Standby or Hibernate while in motion. Press Volume Up and Down
simultaneously to enter 2D mode (status light is off) before storing the device
if motion is expected.