Officezone Educator Operation Manual - 4-1 Safety Precautions:
4-1 Safety Precautions:
DANGER
1. High temperatures are present and care should be exercised in operating and
maintaining the laminator. Even after the machine has been turned off it
will remain hot for an extended period of time. Contact with hot surfaces
may cause burns.
2. Always make sure the power cord is not placed under the laminator where it
might get overheated from proximity to the bottom heat shoe.
DANGER
3. The safety shield must remain attached to the machine and in position any
time there is power to the machine. You may tip the safety shield down while
loading the film. Always make sure the rollers are NOT turning when the safety
shield is flipped down.
DANGER
4. Never operate the laminator with neckties, jewelry, or lose clothing. Tie
back long hair. These items can be caught and be pulled in by the laminator
causing serious injury.
5-1 Setup & Operation
With the laminator on an unobstructed, level surface, perform the following checkout
before threading the machine with film.
Warning: Make sure the power cord is clear of the underside of the machine prior
to operation to avoid overheating the cord.
1. Remove all packing straps, rubber bands, tape, and plastic ties from the machine.
Remove the protective paper from the safety shield.
2. Turn the heat/power switch to the Off position. Move the drive switch to the
middle/Off position.
3. Plug the machine into a working outlet of at least 15 amps. Plugging in the
machine does not power on any control unless a switch has been left on.
4. Turn the heat/power switch to the ON position. The heat indicator lamp in the
heat switch will come on. It will stay on until the machine has reached set
temperature.
5. Once the heat is turned on, it will stay on until the switch is manually turned off.
There is no automatic shutoff on this machine, except in the case of a blown fuse.
6. Turn the heat/power switch on the ON position. The heat indicating light will go
on.
7. Turn the drive switch to FORWARD position. The pull rollers and the
laminating rollers should rotate. The fans will operate while the drive motor is
ON.
8. Turn the drive switch to the OFF position.