Officezone Educator Operation Manual - page 15

3.  With the roll aligned with the scored line on the right side of the mandrel, place it 

in the top bracket.  Place the left side of the shaft in its slot first, then place the 

right side of the shaft in its slot, turning it as needed.  FOLLOW THE 

RECOMMENDED LOADING PROCEDURES CAREFULLY WHEN 

THREADING FILM IN THE LAMINATOR.  ACCURATE ALIGNMENT OF 

ROLLS WILL MINIMIZE WASTE AND HELP KEEP THE LAMINATOR 

CLEAN. 

4.  While the machine is still cold, review the threading diagram.  With the bottom 

roll of film centered on the mandrel and the shiny side facing down, run the film 

under the bottom idler bar and pull towards you. 

5.  Refer to the threading diagram.  The top roll of film should run under the silver 

stabilizer bar and over the front of the top heat shoe.  Remember, the shiny side of 

the film must always go against the shoe.  The dull (adhesive) side must face 

away from the shoe.  Make sure the two rolls are aligned with each other before 

going to the next step. 

6.  Turn the machine on and heat to the desired temperature. 

7.  With both rolls threaded and installed in their respective brackets, unwind enough 

film from the top roll to reach the bottom of the bottom heat shoe.  Next, unwind 

enough film from the bottom roll to reach the top of the top heat shoe.