OHAUS SPX1202 Instruction Manual - 4.3 Setup Menu
EN-10 SCOUT
TM
SERIES BALANCES - SPX
4.3 Setup Menu
Enter this menu to set balance parameters.
Note: Bold always represents factory default value
Reset
[reset]
Reset the Setup menu to factory defaults.
NO
= not reset
YES = reset
Filter
[FILtEr]
Set the amount of signal filtering.
LOW
= less stability, faster stabilization time
MED
= normal stability, stabilization time
HI
= greater stability, slower stabilization time
AZT
[AZt]
Set the automatic zero tracking functionality.
OFF
= disabled
0.5d
= the display will maintain zero until a change of 0.5 divisions per second has
been exceeded.
1d
= the display will maintain zero until a change of 1 divisions per second has been
exceeded.
3d
= the display will maintain zero until a change of 3 divisions per second has been
exceeded.
Stable Range
[Stable]
Set the amount the reading can vary while the stability symbol remains on.
0.5d
= 0.5 balance division
1d
= 1 balance division
2d
= 2 balance division
5d
= 5 balance division
Back Light
[LIGHt]
Sets backlight functionality.
OFF
= always off
ON
= always on
AUTO = turns on when a button is pressed or the displayed weight changes.
Note: When connected with power pack, the backlight is always on.
Auto Tare
[A.tArE]
Set the automatic tare functionality.
OFF
= Automatic Tare is disabled
ON
= the first stable gross weight is tared
ON-ACC = stable gross loads within the accept limits are tared (in Check weighing mode)
Reset:
no
, yes
Filter:
Low, Med, High
Auto Zero Tracking:
off, 0.5d, 1d, 3d
Stable:
0.5d, 1d, 2d, 5d
Backlight:
off, on, auto
Auto Tare:
off
, on, on-acc
Auto Off:
off
, 1, 5, 10
End Setup:
Exit menu
(866) 433-6682 • (281) 359-8538 • sales@novatech-usa.com • www.novatech-usa.com