OHAUS Valor 1000 Instruction Manual - 3.6 Check Weigh Mode
EN-5
OHAUS Valor 1000 Series
next sample. Repeat this process until all samples have been weighed.
Review the accumulation data by pressing M+ when the display is at zero.
The display shows the number of samples [n----x]
Press M+ to view the maximum sample weight [Hxxxxx].
Press M+ to view the minimum sample weight [Lxxxxx].
Press M+ to view the sum of weights [xxxxx].
Press M+ to return to weighing.
Clear the accumulated data by pressing ZERO when the number of samples is
displayed.
3.6 Check Weigh Mode
Use this mode to compare samples to a target weight range.
Press ZERO to set the display to zero. Place a sample on the pan and read the weight
and under / accept / over status on display.
(Refer to section 4.1 to set limits)
3.7 Changing Units of Measure
Press and hold the M+ and SELECT buttons to display the next available measuring
unit.
4. SETTINGS
The scale allows the user to customize several settings including check weigh limits,
backlight operation and calibration.
4.1 Over and Under Limits
Press and hold ZERO and press SELECT until [SET---] is displayed.
Press SELECT to display [SET-F0]
Press ZERO to view the upper limit [000000].
Press
§, ©, ª to edit the upper limit.
Press ENTER to confirm the setting and display the lower limit [000000].
Press
§, ©, ª to edit the lower limit.
Press ENTER to confirm the lower setting and display will show Run---X where x is the
alarm setting. In this case x=
0 = Turns off check weigh mode
1 = under / accept / over indicators are displayed, alarm beeps when
weight is outside accept range.
2 = under / accept / over indicators are displayed, alarm beeps when
weight is within accept range.
3 = under / accept / over indicators are displayed, alarm is off.